Dispenser location

1. Dispenser should be installed in a well-ventilated spot with minimum 5 cm free space all around it.
2. Ambient temperature in the room where it is located should never be lower than 0 'C.
3. Dispenser should not be installed, or bottles with water stored in places with high solar exposure, near sources of heat, or next to plants, or in dusty rooms.

Dispenser installation and use

1. Your dispenser will be first installed and put into operation by our representative.
2. If you want to move the device to another spot, proceed as follows:

• Remove the bottle even if it contains water, switch off heating function, disconnect power supply and empty the drain pan.
• While being moved or transported the dispenser must always be in vertical position; wait 15 minutes before you turn it on again. 
• The machine should be connected to a socket with earthing-pin.
• Before replacing the bottle, remove the protective sticker from the cap. 
• After full bottle is in place press the hot water tap (red), and then cold water tap (blue) and hold it until the water flows in full stream.
• Wait until air bubbles in the bottle disappear and then connect the dispenser to power supply.
• Turn the heating switch at the back of dispenser from position "0" to "1".
• After about 20 minutes, check whether the machine water heating and cooling functions operate properly.

3. In case of any dispenser malfunction, please, contact our Info Line 0 801 222 888.